01
Phone Intake
You call (833) 929-5837 and tell us what was remediated, when, and by whom. We ask about the rooms involved, whether containment came down, and whether any water source was fixed. That call takes about ten minutes and sets the scope. We schedule a same-day or next-day visit, including evenings for commercial jobs.
02
Visual and Moisture Check
On site, we walk the work area with a moisture meter and thermal imaging camera. We check drywall, baseboards, and framing for lingering dampness, because mold will not stay gone in wet material. A boroscope goes into wall cavities where remediation was performed. This step takes 20 to 30 minutes on a typical Harbor City home.
03
Air and Surface Sampling
We run calibrated air sampling pumps for five to ten minutes per location, plus one outdoor control sample. Affected rooms get at least one indoor sample each. If surface residue is a concern, we take tape-lift or swab samples from framing and ductwork. Everything is labeled, sealed, and logged with chain-of-custody paperwork.
04
Lab Analysis
Samples go to an accredited microbiology lab, usually with results back in 24 to 48 hours. The lab identifies spores by genus and reports raw counts alongside the outdoor baseline. Rush turnaround is available when you are on a closing deadline or a tenant is waiting to move back in.
05
Report and Next Steps
We walk you through the results in plain language. If counts are at or below outdoor levels, you get a clearance letter you can file. If something is elevated, we tell you which room and which genus, and what needs to happen next. You are never left holding a PDF with no explanation.